POST
|
Don, I will have to try turning off the basemap right away and running the processing again on my laptop. As soon as I hit start I try to not touch anything again until it is done. I did try to run D2M on a desktop work station today. Not only did I crash D2M, but I also froze the whole machine. My apologies to the billing department. I think I need to check to make sure the Microsoft Visual C++ 2008 Redistributable - x64 9.0.30729.6161 is installed on this computer and make sure everything else is up to date as well. There shouldn't really be any other reason why D2M shouldn't be able to run on this machine. Currently I've only been able to get away with running rapid on my laptop but I would like to be able to run the 2D and 3D without too many crashes. I will try again on the desktop tomorrow. Tony - I have tried uninstalling and re-installing D2M on my laptop and running repairs, but I believe my only solutions to ending all crashes is a better computer. Not sure what is going on with this desktop, it isn't updated as much as it should be so I'll need to look into that.
... View more
09-07-2016
01:44 PM
|
0
|
5
|
678
|
POST
|
Thank you for this tip. I uninstalled and re-installed the Microsoft Visual C++ 2008 Redistributable - x64 9.0.30729.6161 and ran a repair on Drone2Map and I was also able to acquire the finished products. The program crashed as soon as they were loaded, but at least they are now there in the folders. As for the crashing problems, I also have mine crash a lot when I pan and zoom. I marked it up to my laptop being hardly able to handle the program. My processor screams at me every time I use Drone2Map or ArcGIS for Desktop. I knew it would happen and I've just dealt with it because I do not have the option of using a better computer at this point in time. However, maybe some of the crashes are due to bugs in the newness of Drone2Map. I wouldn't be surprised if it were fixed in the near future for those who's computers are actually built to handle these programs.
... View more
09-07-2016
07:01 AM
|
0
|
11
|
678
|
POST
|
What is the next step after making sure this is installed? I have the same problem as above, and if I then try and process another set of pictures, or the same set, the processing goes right to completed. I have the trial and I need to know if this is something that could be proposed to the company I work for, but I need to be able to see results and be able to manipulate results. When the processing goes right to completed, I have to run a repair and then I can process another set of pictures before the same things happen once again.
... View more
09-06-2016
09:11 AM
|
1
|
0
|
1181
|
Title | Kudos | Posted |
---|---|---|
1 | 09-06-2016 09:11 AM |
Online Status |
Offline
|
Date Last Visited |
11-11-2020
02:24 AM
|