polygon to cad with different projections

538
1
01-12-2017 09:02 AM
MikeFroese
New Contributor II

I am having to use data (polygon) that is WGS 1984 UTM and need to put it into NAD 1983 State Plane.

I take the shapefile change from WGS to State Plane. I then export to CAD and open up the CAD file to find that the units did not carry over (WGS metric, State Plane Ft) so it is about 3 times less than it should be

Any suggestions

0 Kudos
1 Reply
DanPatterson_Retired
MVP Emeritus

Just to clarify, you are using the Project tool and not the Define Projection tool I hope in the projection of the shapefile

0 Kudos