I am running a FindPath on two points. The two points have been snapped to the geometric network. One landed on a junction, one landed on an edge, apparently
I am getting the following error when I run Trace Geometric Network with the "FindPath" option
both junction and edge origins are specified for FindPath
I cannot prevent points from snapping to junctions, so how can I rid myself of this annoying error? I will do this a LOT, so it would be nice if I didn't have to futz around with the points to make sure none happen to land on junctions.
Is there a way to say "ignore junctions" or "treat junctions as edges"
Thank you very much,
Randy McGregor