POST
|
Ryan and Denise, Thanks for your responses. I'll admit that I don't think we've done any GPS work since ArcPad 7, so maybe it's a little different that I remember. I'm pretty sure last time I did a GPS export I was using the Get Data for Arcpad 7 button, not the AXF button. Either way, we'll be sure to use the correct workflow going forward. Thanks again Nick
... View more
11-01-2012
05:50 AM
|
0
|
0
|
368
|
POST
|
Ryan, thanks for the response. Are you aware if this changed recently? I am 98% certain we worked with the same project day in and day out and just checked in the data at the end of the day. Just now I exported a feature class to ArcPad and went out and shot a point. Checked it in. Fine. Then I went to check it out again and I cannot use the same as the project before "a folder with that name already exists" This means when we check-out we have to either delete the folder to re-export or export with a new name and I am 100% sure that we didn't do that before. I had it rather streamlined so it was bring in the GeoXH, dock it, let it sync, open ArcMap, check-in, done. And we would just repeat that part of the process the next day.
... View more
10-31-2012
06:07 AM
|
0
|
0
|
368
|
POST
|
To start off, a little bit of background: We're using ArcGIS 10.0 SP3 with GPS Analyst 2.30, ArcPad 10 with GPSCorrect 3.14 on a Trimble GeoXH 2008. We haven't done any GPS collection in a while and I'm having an issue getting back into it. From what I recall, I used to be able to check out a feature class for disconnected editing in the field where we would GPS some features. I would come back and check the data in. The following day I could go out again and collect additional data with the same project in ArcPad without re-checking the data out and then check it back in that afternoon and it would bring in the new data. What I am experiencing now, is I am not able to check in data more than once. If I go out and collect 10 points, the first check-in results in 10 new features. If I then go back out with the same ArcPad project and collect 20 more points, when I check-in, the tool dialog indicates there are no new or modified features. If I tell it to run anyway it says it imported a bunch of GPS points but no new features are created. Am I just going about this in the wrong manner, despite what I remember doing before? Thanks!
... View more
10-30-2012
06:40 AM
|
0
|
4
|
831
|
POST
|
Well I figured out how to emulate the hatch outside the tile. This assumes your layers are transparent to the page, i.e. the layers I load are all linework, so there are no polyfills. Below all my layers I have two additional layers, one that is a white fill with no outline, and one beneath that with the hatch. You can then clip the white fill layer to the data driven layer using the new Clip Option in the Data Frame Properties window to "Clip to current data driven page extent" This clips just the white background layer to your current tile and lays it over the hatch layer giving the illusion that the hatch is cut around the tile.
... View more
07-22-2010
08:20 AM
|
0
|
0
|
704
|
POST
|
So, is there a way, with the new Data Driven Pages to: Hatch outside the tile Double click on a particular page to bring it up without scrolling through them all Label neighboring tiles that are not in a rectangular grid
... View more
07-22-2010
07:33 AM
|
0
|
0
|
704
|
Online Status |
Offline
|
Date Last Visited |
11-11-2020
02:23 AM
|